sheetrock walls between AP and Client. Location #3: Client in upper level, approximately 25 feet away (direct path) from AP. One wood floor, sheetrock ceiling, no walls between AP and Client. Location #4: Client on upper level, approximately 55 feet away...

walls, one wood floor, one sheetrock ceiling and stainless-steel refrigerator, between AP and Client. Location #5: Client on upper level, approximately 65 feet away (direct path) from AP. Four to five interior walls, one wood floor, one sheetrock ceiling,...

approximately 6 feet apart. Location #2: Client in room on same level, approximately 30 feet away from AP. Two sheetrock walls between AP and Client. Location #3: Client in lower level, approximately 40 feet away from AP. One wood floor, no sheetrock ceiling,...

expect from a good 802.11b setup. The toughest test was under Condition 3, which has the signal passing through only two sheetrock walls, but at a very sharp angle on both walls. Although I'd never realized it before, this makes the wall look much thicker to...

Technology WZR-RS-G54 - in various rooms in my home. The Buffalo router was in my office, the Belkin about 40 feet and two sheetrock walls away and the Linksys about the same distance, but on a path that cut diagonally through about four walls. The Hotspotter...

1-2 bar difference between the two during each test, with the ZyXEL barely outperforming the TRENDnet (Table 1). Location ZyXEL AG-225H TRENDnet TEW-509UB 2 m (6') from AP, same room 5 bars 5 bars 9 m (30') from AP, same floor, 2 sheetrock walls between...

that was bridged to the WRT54G (yellow lightning bolts in Figure 5). The second set moved the WRE54G to a room on same level of my home, approximately 30 feet away from AP with two sheetrock walls between AP and WRE54G. The wireless client was also moved to...

limited range, with the inability to run tests at both my longer-range Location 3 and 4 test positions. And even in my Location 2, which is approximately 30 feet away with two sheetrock walls between AP and Client, you can see that the link between client and...

another over the wireless link and I saw no glitches or artifacts! For a range test, I moved the MP115 to a spot about 30 feet or so away, but with a floor and a couple of sheetrock walls between it and the basement AP. Note that the furnace room also has a...

recent MIMO print reviews about poor True MIMO close-range performance being caused by signal overloading. So I moved the notebook with True MIMO client to my Location 2 (approximately 30 feet away and two sheetrock walls between AP and client) and re-ran the...