endpoint pair. Regardless of what type of script was run, you can compare relative precision values. The relative precision is obtained by calculating the 95% confidence interval of the Measured Time for each timing record, and dividing it by the average Measured...

The relative precision is obtained by calculating the 95% confidence interval of the Measured Time for each timing record, and dividing it by the average Measured Time. This number is then converted to a percentage by multiplying it by 100. The lower the Relative...

apples-to-apples comparison for heat output. We created a synthetic heat measure that we call "heat product" by calculating the volume of the tuner capsule (values are in millimeters in HLW order in the table below), then dividing by the average temperature...

Dividing the highest average frame rate by the lowest gives the slower machine a score of one (100%). A huge average lead of 68% in F.E.A.R, and a smaller average lead in Doom 3, shows the Alienware Area-51 SLI system nearly 50% faster on average in games....

than the same plots for displays with lower brightness and smaller standard deviations of brightness. When we divide a display's standard deviation of brightness by the average brightness of the display, we get a number that relates well to what we see in plots...

the same plots for displays with lower brightness and smaller standard deviations of brightness. When we divide a display's standard deviation of brightness by the average brightness of the display, we get a number that relates well to what we see in plots...

connector (still not yet widely available) or a Dual Link DVI cable. To tell the difference between a DVI Dual Link and a standard DVI cable, you need to look at the pins at each end. If there is a small gap dividing two blocks of nine pins, then you have a...

up and downlink (click image to enlarge) Figure 12 shows the total WQS rankings, which include both uplink and downlink tests. (WQS is calculated by adding together the Average Throughput divided by the Relative Precision for each test location.) So that you...