you’ll use to open a crash dump of interest. After that you must wait for debug symbols to load before you examine the crash dump. I usually find this debug command string tells me what I need to know: !analyze -v;r;kv;lmtn  Here’s a snapshot of a recent...

it's especially important for APs in WDS networks, since you'll know where to look for each AP and have one less variable to consider when trying to debug a broken connection. Make sure that you assign the static IPs outside the range of your LAN's DHCP server...

and receive type of data for both the Ethernet and wireless parts of the AP. There's no ability to look at statistics on an individual IP address basis, so it would be hard to debug a particular user's problems, for example. Figure 4: Logging The...

the usual "early adopter" bugs, but also recognize that this technology is a work in progress. You are going to pay for the privilege of helping Broadcom debug their chipset, firmware, and drivers, and also come up the learning curve on wireless networking...

able to successfully print, but at very slow speed. The tech offered to replace the AP and check out the one I had upon its return, but I had run out of time to spend trying to debug the problem. The Belkin tech said she'd personally successfully tested the...

fatal flaw. The complete lack of monitoring features is simply not acceptable for a wireless Access Point, and especially one with wireless bridging features. Wireless networks are hard enough to debug without depriving users of the ability to see whether their...

the fact that I have only a 128K ISDN Internet connection, but delays could be caused by other factors. At any rate, I feel that the application should let the user know what's going on. There's also no logging available for debug or other purposes, other than...