to measure WLAN to WAN throughput. The top trace shows average wireless uplink throughput of 23.7Mbps without the router in the picture and 16.5Mbps with the router cut in - slightly over 30% throughput reduction due to the router. Figure 9: 3Com WLAN-WAN...

the test unit, I was emailed a firmware update which was said to improve throughput.  ASUS was correct. After upgrade and using the same testing setup, my LAN to WAN throughput jumped to an average of 38.7 Mbits/sec, and WAN to LAN increased to an average...

router and the laptop each a static IP address, I configured Mercury as a DMZ host using the GP2's web utility. I then ran 3 tests using iperf in each direction and averaged the results to obtain measured LAN to WAN throughput of 24.2Mbps and 26.1Mbps for WAN...

So What's New? The single chart was getting a bit dense and confusing with trying to display three different throughput results. So we've separated it into three separate charts: WAN to LAN Throughput LAN to WAN throughput Total Simultaneous throughput We also...

V5 Really Is a Lousy Router article. Both came in at the bottom of the Total Simultaneous Throughput chart and in the middle of the WAN to LAN and LAN to WAN throughput charts. The fastest of the draft 11n routers was the Netgear WNR854T, with 116 Mbps of Total...

breakup in the recorded message. While I had the BTS on the test bench I decided to check its routing performance. LAN to WAN throughput was between 60 - 61 Mbps with ping time of 1mS - as low as Qcheck measures. WAN to LAN throughput averaged between 56 - 57...

throughput from transfers originating on the WAN side of the router - like someone accessing an FTP, gaming or web server hosted on the router's LAN side from the Internet would experience. So I set up an FTP server on the WAN side of the router and used IxChariot's...

Default Server" connected to the LAN. Direction Throughput LAN to WAN 9.62 Mbits/sec WAN to LAN 9.27 Mbits/sec Table 2: Router Throughput Test Results The LAN to WAN and WAN to LAN results are disappointing, since I expected throughput to be at least...

Uplink (click image for larger view) Figure 13 shows a combination plot of the tests comparing AP and routing throughput in the WLAN to WAN direction. The top trace shows average wireless uplink throughput of 23.4 Mbps without the router in the picture and...

available that improves dual-WAN load balancing features. - Nexland purchased by Symantec and pro800Turbo no longer available Pros • Dual 10/100 WAN ports with auto-failover and load balancing • Supports 16 WAN IP addresses • High throughput Cons...