Our test uses IxChariot's Throughput.scr IxChariot script with the defaut 100,000 Byte file size changed to 1,000,000 Bytes. Three tests are performed, each one minute in length: •WAN to LAN - Data flows from the WAN-side IxChariot endpoint to the LAN-side...

Gigabit products respectively. These plots were created using an Azimuth MIMO Rate vs. Range script that interfaced with IxChariot to generate the data traffic and the Azimuth system to control signal attenuation. The test used the same modified IxChariot throughput.scr...

• -Test Results

match the settings of the other products that used that technology. I also configured each router to act as an an Access Point, so the test results are in no way effected by the router portion of the products. At each test location, the IxChariot Throughput.scr...

test setup All routers / APs are generally reset to factory defaults and configured to act as access point, so the test results are in no way effected by the router portion of the products. At each test location, the IxChariot Throughput.scr script (which is...

the best-case performance, and then connected them into my home's cable TV or phone wiring. I used IxChariot and ran TCP throughput and UDP streaming tests on both devices. Throughput was tested with IxChariot's throughput.scr script with the only change from...

MB RAM and WinXP Home SP2 and a Fujitsu S2020 Notebook with AMD Athlon XP-M 2100+, 496 MB RAM and WinXP Home SP2. I used the IxChariot throughput.scr script with TCP/IP protocol and modified the default 100,000 Byte file size parameter to 1,000,000 Bytes. Figure...

• -We Have A Failure To Communicate

required by the content. Figures 6 and 7 illustrate the rule, showing IxChariot plots of a single wireless connection between the "Home" WRT54G and WPC54G client card. Figure 6 starts out with an IxChariot throughput.scr script running TCP with a file size...

Win XP SP2) into the 728TS, initially setting the CoS for both notebook ports to 0. I then set IxChariot to use the IxChariot throughput.scr script, to send TCP/IP data simultaneously from both notebooks to the desktop for about a minute. During the run, I...