feature at minimum shows you the IP address and MAC address of clients that have a DHCP "lease" (assignment). Sometimes the control to invoke this feature is conveniently located on the DHCP server page. But other times, such as in Figure 3, it isn't. Lease...

server on the PORTAL interface using the 'check-box' at the top of the screen. Figure 3: Portal Interface DHCP configuration (click on the image for a larger view) As I am not expecting lots of users, I have left the DHCP lease times at their default...

you already have a DHCP server on your network. Client Listing Sometimes it's handy to see what's connected to your LAN. This feature at minimum shows you the IP address and MAC address of clients that have a DHCP "lease" (assignment). Some products also let...

settings IPCop provides a DHCP server so that LAN clients can all grab an IP address along with proper gateway and DNS information As Figure 18 shows, start and end addresses of the DHCP range can be specified, along with DNS servers and DHCP lease duration....

some computers may not get a DHCP lease at all if the campus DHCP server never gets to answer the request. This is bcasue most consumer routers are configured to hand out only a few dozen addresses. Once the limited number of leases has been exhausted, the...

If DHCP leases are failing to renew, go to a different table and try from there. If you still get get a DHCP lease, chances are the problem is with your DHCP server. Try restarting the service and perform standard troubleshooting there. Try pinging various...

having DNS connection problems. You can, of course, enter all required information if you give the device a static IP. 6/27/2004 - Acting on a tip from Sychip, I verified that the DHCP lease problem reported above was due to the DHCP server in the OvisLink...

controls are not located here, but in the Advanced Setup section. You can set four different DHCP ranges and reserve IP addresses by MAC address, but you can't set DHCP lease time or force lease terminations to disconnect unwanted clients. The Primary WAN screen...

setup is straightforward, with the DHCP server enabled and ready to go. A nice touch is that you can set the DHCP Lease time in programmed increments from 30 minutes to 2 weeks, or have the lease never expire. The overall responsiveness was pretty good with...

All the System Log shows is Startup and some DHCP lease info, the URL Log shows one URL per client IP address and I never heard a peep from the email Event Report capability even when I port-scanned the crap out of both products. The DHCP Lease report appears...