The WRT55AG / WPC55AG has much lower maximum and average throughput under best-case signal conditions 2) The WRT55AG / WPC55AG has much higher throughput variation in all test locations. Figure 9: Four Condition Throughput test - WRT54G (click on the image...

the second draft-11g client kicked in. I, of course, ran my usual four-location throughput test, the results of which are shown in the chart at the top of this section. I also did Chariot runs, which are shown in Figure 17. Figure 17: Four condition throughput...

running in that mode. Figure 11 shows the results. Figure 11: Four Condition Throughput test - WiFiSec mode (click on the image for a full-sized view) As you can see, the TZW had consistent throughput in all of my test locations, but with 3Mbps average throughput...

usual four-location throughput test, the results of which are shown in the chart at the top of this section. I also did Chariot runs, which are shown in Figure 14. Figure 14: Four condition throughput (click on the image for a full-sized view) I...

throughput test results (click on the image for a full-sized view) Note that his pattern is similar, but worse than, the results I obtained when I tested the Linksys WRT54G and WPC54G (Figure 6). Figure 6: Four Condition Throughput test - WRT54G and WPC54G...

throughput test results in Figure 18 show best-case performance of 24Mbps, which is comparable to other 802.11g products running without any of the myriad throughput enhancement technologies. Figure 18: Four Condition Throughput test (click on the image...

8: Four Condition Throughput test - WRT54G and WPC54G (click on the image for a full-sized view) You can see that both product generations have similar throughput vs. distance characteristics in that they drop down from their best-case speeds pretty quickly....

I see when testing 802.11b product. It's worth noting, though, that my worst-case Condition 4 throughput of about 4.8Mbps is about equal to the best throughput that typical 802.11b equipment provides. Also in Linksys' favor is that enabling WEP doesn't appreciably...

support website. I ran my usual four-location throughput test, the results of which are shown in the table above. I also did Chariot runs, which are shown in Figure 6. Figure 6: Four Condition Throughput - NETGEAR (click on the image for a full-sized view)...

UDP stream Throughput (kbps) Lost data (%) Client to AP - Condition 1 55 4.55 [No WEP] 3.14 [w/ WEP] 176 (avg) 253 (max) 494 0 Client to AP - Condition 2 44 4.46 179 (avg) 264 (max) 493 0 Client to AP - Condition 3 26 4.44 180 (avg) 321 (max) 493...