- relevance
- date |
- Sort by :
-
Wireless Ethernet Bridges
- Reviews
Point-to-Point or Point-to-Multipoint bridges by using AdHoc mode instead of a special bridging mode. This use of AdHoc mode allows WEBs to do one thing that AP/Bridges can't do. Figure 4 tells the tale. Figure 4: Wireless Network using AdHoc mode If you compare...
-
Setup
- Reviews
note that the settings are not the defaults. The wizard steps you through screens that allow you to: Select AdHoc or Infrastructure mode Set (E)SSID, Channel (AdHoc only), and Bridge Name Manually set IP address, subnet and Gateway, or get that info from a...
-
Wireless Performance
- Reviews
was done with a Linksys WPC54G card in AdHoc mode in a Dell Inspiron 4100 laptop running WinXP Home Rather than lug around the WET connected to my laptop, I plugged one set to AdHoc mode into my LAN's switch and used a Linksys WPC54G card also set to AdHoc...
In this review -
The big difference(s)
- Reviews
using Configuration mode, however, and multiple profiles can be saved and enabled as needed. Figure 7 shows a Client profile for an AdHoc connection. Note that WPA-PSK is not supported in AdHoc client mode, just WEP 64 / 128. Figure 7: AdHoc Client mode...
-
Setup and Administration
- Reviews
need to correct an oversight. It is possible to set the channel in AdHoc mode, but I found a small bug in the Channel selector. When you select AdHoc mode, the Channel selector comes alive. But the channels available in the selector don't immediately change...
In this review -
Failed experiments
- Reviews
discourages this, the product could still be WPA and Wi-Fi Certified. No AdHoc support WPA currently supports Infrastructure mode only, with AdHoc mode support delayed until WPA2. The larger impact of this missing feature may be on Wireless Ethernet Bridges...
-
Wireless Performance
- Reviews
Home • Wireless settings were Channel 6, Mixed mode Rather than lug around the WET connected to my laptop, I plugged one set to AdHoc mode into my LAN's switch and used a Linksys WPC54G card also set to AdHoc mode to do the testing. As both the table above...