Put parts from one computer into a new case and now have a problem.

I put my part of my one computer into a new case so I could make room for a new computer but I have a little problem now. All I did was to take all my parts out of my one case which I will be putting new parts in and put them into my new case and in my device manager now I have an exclamation mark in other devices and it says pci device. I did not put any new parts in I just had to take them out to move the mobod etc. The only thing I have in a pci slot is an audigy 2 zs gamer which has not caused me any problems before. It works great and everything seems to be fine. I have xp pro with an amd 4400+ along with and ati 2600xt.
Anyone seen this before?

I have reseated and moved to another pci slot. The card is functioning fine. Sound and things work great. I have never had to reset the cmos. What do you do?

That's what I thought also so I checked and it was disabled.

Instrucitions will be in the mobo manual. Usually just involves moving a small plastic cap over one pin, first unplug the computer, wait a minute and move the cap back to the original pins. The pins and cap are near the battery on the mobo

Now you have to find out what key to press during the POST to get to the BOOT sequence menu in BIOS.

Or, just enter the BIOS and select or move "Boot from Hard Disc" to the number 1 position.

If your winxp is on a sata drive, you might have to enable the sata controller in the bios.

I have tried hard drive first, and then removeable disk and then cd and tried and tried.

I got it to go. I had to go into bios and set which hard drive to boot off of. I have never had that happen before. Anyway the clear cmos did not work. The mark is still there. AAAAAAAAHHHHHHHHHHHH.

The disc boot thing............... first thing would have been to check the connections.

The sound card. go into the device manager and see if it will un-install. Either way, remove it and plug the speakers into the onboard sound. Restart. Sound should work.

Try and reinstall the card and drivers.................. make sure in the bios it's set to auto. ...... or disabled if that's the only option you have.......... ( onboard sound before you install the card )

You may also want to try an older driver.

Did you delete it? If you delete it, then it might not come back. If the error in the device manager isn't causing you any problems, then you could just leave it. You could try updating your mobo drivers, although it's doubtful that will help.