Tom's Guide > Forum > Overclocking > General Discussions > Owner of three blown POST Diagnostic Cards requires your h..

Owner of three blown POST Diagnostic Cards requires your h..

Forum Overclocking : General Discussions - Owner of three blown POST Diagnostic Cards requires your h..

TomsGuide.com: Over 800,000 questions and answers to address all your high-tech questions. Sign up now! Its free!
Word :    Username :           
 

Archived from groups: sci.electronics.repair,alt.certification.a-plus,alt.comp.hardware.homebuilt,alt.comp.hardware.overclocking (More info?)

 

Owner of three blown post diagnostic cards requires your help...
Problem is that China Inc. actually went through the trouble
to grind off the chip part numbers :-(
Though "debug cards" can now be had for as low as $10, there
is the desire to refine one's surfacemount soldering skills
and to replace what looks like 10 cent TTL glue logic.

Here is a picture of the same card I have, but with part numbers:
http://cgi.ebay.com/ws/eBayISAPI.d [...] egory=1244

All the cards sold now look like they retain their chip part
numbers. Most of the inexpensive PCI-ISA post cards from the
various vendors appear to use the same generic circuit. An
observation based mainly on:
- common features
- pdf manual downloads on vendor sites
- chip count plus the same number of 14, 16 and 20 pin chips
The only difference being variations in layout and quality.

If someone purchased this type of card with chip part numbers,
could you either post or e-mail the numbers on the following
ten chips.

U2 -
U3 - (looks like a 74LS02 in the above picture link)
U4 -
U5 - (looks like it reads 74LS04)
U6 -
U7 -
U8 - (looks like GAL16V8)
U9 - (looks like GAL16V8)
U11 -
U12 - (looks like 74F74)

Even better would be if someone has a schematic diagram or went
through the bother to trace one out. If the GAL16V8 chips are blown
one would be SOL, but there is glue logic between them and the bus.


As they say... Strike three and you're out...

Sponsored Links
Register or log in to remove.

Archived from groups: sci.electronics.repair,alt.certification.a-plus,alt.comp.hardware.homebuilt,alt.comp.hardware.overclocking (More info?)

 

Electronic Components wrote:
> Owner of three blown post diagnostic cards requires your help...
> Problem is that China Inc. actually went through the trouble
> to grind off the chip part numbers :-(
> Though "debug cards" can now be had for as low as $10, there
> is the desire to refine one's surfacemount soldering skills
> and to replace what looks like 10 cent TTL glue logic.
>
> Here is a picture of the same card I have, but with part numbers:
> http://cgi.ebay.com/ws/eBayISAPI.d [...] egory=1244
>
> All the cards sold now look like they retain their chip part
> numbers. Most of the inexpensive PCI-ISA post cards from the
> various vendors appear to use the same generic circuit. An
> observation based mainly on:
> - common features
> - pdf manual downloads on vendor sites
> - chip count plus the same number of 14, 16 and 20 pin chips
> The only difference being variations in layout and quality.
>
> If someone purchased this type of card with chip part numbers,
> could you either post or e-mail the numbers on the following
> ten chips.
>
> U2 -
> U3 - (looks like a 74LS02 in the above picture link)
> U4 -
> U5 - (looks like it reads 74LS04)
> U6 -
> U7 -
> U8 - (looks like GAL16V8)
> U9 - (looks like GAL16V8)
> U11 -
> U12 - (looks like 74F74)
>
> Even better would be if someone has a schematic diagram or went
> through the bother to trace one out. If the GAL16V8 chips are blown
> one would be SOL, but there is glue logic between them and the bus.

Can't help with the chip numbers, but I note that my PCI-only diag card
has 3 x GAL16V8D only (socketed), no TTL glue at all - which suggests
it's only needed on the ISA side.

> As they say... Strike three and you're out...

Reply to Anonymous
Tom's Guide > Forum > Overclocking > General Discussions > Owner of three blown POST Diagnostic Cards requires your h..
Go to:

There are 11 identified and unidentified users. To see the list of identified users, Click here.

Please mind

You are about to answer a thread that has been inactive for more than 6 months.
If you still wish to proceed, please ensure that your posting is original and does not duplicate or overlap any prior responses to this thread.

Add a reply Cancel
Google ads