JBL 4312C speaker black veneer covering

visionseekr

Honorable
Apr 26, 2013
1
0
10,510
Hello, I have a pair of 4312C JBL control monitors that are covered in what appears to be black vinyl veneer. I would like to remove it and re-veneer these speakers with a wood veneer. Any suggestions on how to remove this existing veneer?
 
The material Tolex, is very difficult to remove, because it is attached with industrial contact cement.
Even solvent will loosen the material, and you can peel it off, but the cement is still stuck to the particle board.
Sanding the contact cement off is slow, and difficult, the cement clogs and sticks to the sandpaper.
It's better to peel off the old tolex with solvent, and glue new tolex on. You could also use a heat gun to soften the contact cement...
It's possible to peel the tolex as above and glue veneer, like Formica, and then trim the edges with a special router wheel.
However not practical...
Or find some wood grain monitors that you can install the JBL components into...it would be a lot easier.