I apologize for duplicate topic (and for bad english), but I need only simple answers, because i getting sick and tired reading all dat quantum of topics and threads on different forums , so, I bought new digitizer (old one is destroyed). Its the same type like old one. I replaced it and now i got problem with it. Some areas of display wont work (especially vertical raw on left side , so i can type letters like "a" and some sectors on right side), so I try everything i found on internet. But I still got some questions because none of them work for me.
1. Should I remove totally all of Old Glue that attached old digitizer to front cover, and make that surface perfectly clean to detail , is there any contacts that can make this problem??? I did it but there is still some small oily spots. { Plz tell me that this is my problem Smiley }
2. Maybe I need only to calibrate new digitizer. I tried it but there is a lot of different size of PG76DIAG.nbh. I tried few but without success. Do I need to *RELOCK* bootloader to run diagnostic and calib of digitizer (unlock by htcdev). Huh
Thx for 2 simple answers , your exp. or everything that could help me in my misery .
1. Should I remove totally all of Old Glue that attached old digitizer to front cover, and make that surface perfectly clean to detail , is there any contacts that can make this problem??? I did it but there is still some small oily spots. { Plz tell me that this is my problem Smiley }
2. Maybe I need only to calibrate new digitizer. I tried it but there is a lot of different size of PG76DIAG.nbh. I tried few but without success. Do I need to *RELOCK* bootloader to run diagnostic and calib of digitizer (unlock by htcdev). Huh
Thx for 2 simple answers , your exp. or everything that could help me in my misery .