G15 Macro i need auto switch to next plz Help!!

[multisync]

Hi,

I must say the program itself of the g15 is really bad as if your macro is too long the program will fail error and won't save it.So what i am asking is if it is possible in any way to start Macro in G-1 key . . . once it is done or after XXX time have past . . . Start macro in G-2 key . . . Then next one blah blah . . . All the G-key in cycle looping all macro set in all my G-key??? Hope anyone can help me doing this.

 

[multisync]

Hi,

I must say the program itself of the g15 is really bad as if your macro is too long the program will fail error and won't save it.So what i am asking is if it is possible in any way to start Macro in G-1 key . . . once it is done or after XXX time have past . . . Start macro in G-2 key . . . Then next one blah blah . . . All the G-key in cycle looping all macro set in all my G-key??? Hope anyone can help me doing this.

what program can i use to make macro the length i want?