Transducer setup Pc to Receiver powering 2 x aura transducers HELP

Solution
The transducers would normally connect to an external amp that is connected to the line level sub out on the receiver.
If your "receiver" came from a HTS is might have a speaker level subwoofer output but that still should be used with a passive subwoofer. The transducers are meant to augment a sub not replace it and you might not be able to power them with the same amp as the sub.
The transducers would normally connect to an external amp that is connected to the line level sub out on the receiver.
If your "receiver" came from a HTS is might have a speaker level subwoofer output but that still should be used with a passive subwoofer. The transducers are meant to augment a sub not replace it and you might not be able to power them with the same amp as the sub.
 
Solution


Sorry, but you're guessing and you're wrong. As they say, RTM.

http://www.parts-express.com/pedocs/installation-guides/299-028-aura-sound-ast-2b-4-installation-guide-1381.pdf

It requires an AMP to power it, 50WATTS RMS @ 4 OHMS.

They are not powered in anyway, and thus need an amplified signal and not a line level, but a powered signal.