So about a year ago I set about building a good home theatre for my home. I had a design that should work out pretty smooth. I bought an Onky HT-RC460 receiver, and have a Klipsch SW-110 subwoofer. And had a corresponding selection of Klipsch speakers to match. However to due to life i wasn't able to complete the speakers at the time. So now am setting out to complete my system again.
Now here is my question. Looking at the new Klipsch models, the R-26F says that it is 8 Ohms compatible at 100/400w. The Onkyo is 100 W (6 ohms, 1 kHz,
0.7%, 2 channels driven) at all channels and 80 W (8 ohms, 20 Hz-20 kHz, 0.7%, 2 channels driven, FTC)
125 W + 125 W (6 ohms, 1 kHz, 0.1%, 2 channels driven, FTC) at the from left and right channels. will this work together with no distortion? or risk of blowing the speakers. I think its the 8 ohms compatible that is throwing me off here. also i had selected the RF-52 II for the center channel. which is running out of stock. Should i get that one. or get the newer RC-62 II? on the rear channels I had selected the the RS- 52 II. but that was discontinued. is the Rp-240s a suitable replacement that would be compatible with the receiver? I know these are pretty specific. and i hope i didn't screw up in my calculations for the system. Thank you in advance for your help.
Now here is my question. Looking at the new Klipsch models, the R-26F says that it is 8 Ohms compatible at 100/400w. The Onkyo is 100 W (6 ohms, 1 kHz,
0.7%, 2 channels driven) at all channels and 80 W (8 ohms, 20 Hz-20 kHz, 0.7%, 2 channels driven, FTC)
125 W + 125 W (6 ohms, 1 kHz, 0.1%, 2 channels driven, FTC) at the from left and right channels. will this work together with no distortion? or risk of blowing the speakers. I think its the 8 ohms compatible that is throwing me off here. also i had selected the RF-52 II for the center channel. which is running out of stock. Should i get that one. or get the newer RC-62 II? on the rear channels I had selected the the RS- 52 II. but that was discontinued. is the Rp-240s a suitable replacement that would be compatible with the receiver? I know these are pretty specific. and i hope i didn't screw up in my calculations for the system. Thank you in advance for your help.
Facebook
Twitter