- Feb 17, 2016
- 9
- 0
- 1,520
I upgraded from Windows 7 to Windows 10.
My original setup included 2 monitors. One connected to VGA on my motherboard and one connected to my HDMI port on my R7 260X. Then changed a setting in the BIOS to allow this.
After the upgrade:
1. Upgraded drivers
2. The monitor plugged into the motherboard is perfectly fine, resolution is perfect.
3. The monitor plugged into the card is not right. I select 1360x768 and it doesn't fit right on the screen.
4. If I go into display settings and shut off the monitor plugged into the motherboard, the resolution is perfectly fine on the monitor in the card.
Any ideas?
Computer Specs:
ASRock FM2A75-M
AMD A8-5600k APU
XFX R7 260X
8gb ram
SSD boot disk
Seagate storage
My original setup included 2 monitors. One connected to VGA on my motherboard and one connected to my HDMI port on my R7 260X. Then changed a setting in the BIOS to allow this.
After the upgrade:
1. Upgraded drivers
2. The monitor plugged into the motherboard is perfectly fine, resolution is perfect.
3. The monitor plugged into the card is not right. I select 1360x768 and it doesn't fit right on the screen.
4. If I go into display settings and shut off the monitor plugged into the motherboard, the resolution is perfectly fine on the monitor in the card.
Any ideas?
Computer Specs:
ASRock FM2A75-M
AMD A8-5600k APU
XFX R7 260X
8gb ram
SSD boot disk
Seagate storage
/support.amd.com/en-us/kb-articles/Pages/latest-catalyst-windows-beta.aspx)
Facebook
Twitter