Acer Aspire 7741-4433 setup utility

Wallace109

Estimable
Jul 6, 2014
2
0
4,510
After powering on I get a black screen with a message to press f2. After pressing F2 I am taken to the Phoenix SecureCore Setup Utility. Not sure what needs to be done on this screen. I have the following main tab options ... information, main, security, boot, and exit
 
Keep your answers in the forum for everyone can read them.

"The only option I have after powering on is F2. After pressing it and getting to the utility setup screen, it will not do anything else. If I don't press the F2 then that black screen just keeps blinking over and over for as long as the computer is running."

On the last option "exit" try to restore the BIOS to default.
 

Wallace109

Estimable
Jul 6, 2014
2
0
4,510
I went to the exit tab and were given the following options .... exit saving changes ...... exit discarding changes ... load setup Defaults.... discard changes .... and .... save changes . I chose the Load Setup Defaults, and then exited sa ging my changes ..... but the screen immediately goes back to blinking black screen with the same message at the bottom to press F2 to enter setup ....... that screen just continues to blink